What should a wing open van pay attention to?

1. Open wings open van carriage before must put the side look at the bottom of the spring hanger saved the effort, or a press button after you open wing van is rising much already deformation, why I can say, is not to say that people's quality of open wing van is very poor, in one fell swoop deformation, that due to the open wing box two hydraulic cylinder, on the edge of the car is to rely on hydraulic props, this energy is quite big, without opening your hook because two energy involved will cause deformation compartment.

2. Do not start the car or move the car under the condition that the wing open compartment is not closed, although sometimes there is no problem, but people want to develop a good habit from the beginning. It is a very risky practical operation to move a wing open van in the situation that it is not closed. Once the side plate of the car and the building collide, the bad effect is unimaginable. People have repaired a wing open van with such illegal behavior, and no casualties have been caused. The production of wing open van can completely avoid the occurrence of such things, because people have to prevent deviation of the actual operation, wing open van does not close, the diesel engine can not start.

3. When opening or closing the wing to open the van, the upper and lower sides must be embedded with sufficient interior space to prevent interference with the side panels on both sides. In addition, do not stand within the circuit of the side panels to prevent damage.

4. Be sure to lock the spring hooks on both sides of the closed wing after opening the compartment, so as not to cause financial damage due to carelessness.

5. The staff of the electric forklift truck should pay attention to the speed of the forklift truck. It is not necessary to hit the wing too hard to open the van board. It should be handled with care during the whole process of the forklift truck.

6. After the wing open van is applied for a period of time, it is necessary to inspect whether the anchor bolts of each connection position are loose and tighten them immediately.